RU EN
Certificate ISO 9001

Motion sensors

selected: 0 compare
IKV-1-3-1 vibration measuring channel IKV-1-3-1 vibration measuring channel

Designed to measure the vibration displacement span in diagnostic and emergency protection systems (EPS)*;

It consists of a DS-1 (DS-2, DS-3) eddy-current transducer and AS131 converter (in the measuring unit), or AS1312 converter on the connecting cable.

Application on the compressor equipment is possible;

Type of output signal – 4...20 mA;

*By default, the channel is set to 40X metal




Add to compare list
IKV-1-4-1 vibration measuring channel IKV-1-4-1 vibration measuring channel

Designed to measure the axial shift in the emergency protection system (EPS)*;

Consists of DS-1 (DS-2, DS-3) eddy-current transducer, AS141 converter (in measurement unit) or AS1412 converter on the connecting cable. If it is necessary to display the measured parameters, additional display units are supplied;

Type of output signal - 4...20 mA;

*By default, the channel is set to 40X metal





Add to compare list
IKV-1-4-1.1 vibration measuring channel IKV-1-4-1.1 vibration measuring channel

Designed to measure speed (factory mode) and phase angle (set by jumper) in emergency protection systems (EPS)*;

Consists of DS-1 (DS-2, DS-3) eddy-current transducer, AS141 converter (in measurement unit) or AS1412 converter on the connecting cable. If it is necessary to display the measured parameters, additional display units are supplied;

Type of output signal – 4...20 mA;

*By default, the channel is set to 40X metal





Add to compare list
DVA334.XXX vibration displacement sensors with digital output DVA334.XXX vibration displacement sensors with digital output

Designed for measurement the range of vibration displacement in emergency protection systems (EPS);

Consist of a sealed housing, which are integrated microelectromechanical acceleration sensor and conversion board;

Sensor versions:

  • DVA334.104 - triangular case, all-in-one cable connection, 3-screw mount;

  • DVA334.132 - triangular case, cable with 2PM connector, mount on 3 screws;

  • DVA334.164 - triangular case, HIROSE connector on cable, mount for 3 screws;

  • DVA334.214 - cylindrical small-sized housing, MIL-DTL connector on the housing, mounting on a stud.   

To install the sensor assembly DVA334.214 uses the standard stud M6x1 (M8x1/M10x1/M12x1); for the special order it is possible to supply the studs with any thread, including inch;  

DVA334.214 allows the use of cable assemblies with MIL connector from imported sensors

Output signal type – RS-485 (Modbus RTU);

Add to compare list

We recommend you to watch

New products

Service center